Table of Contents
Advertisement
2-11-3. In other case
A
<AW operation screen>
2-11-4. In the case the device remains in the finished state of previous sewing
A
<Data input screen>
(In the case one or two bobbins are loaded in the device (including
the hook) other than the case (2).)
1)
Turn the power to the device.
2)
If a bobbin is loaded in the bobbin setting section, take it out.
3)
If any other bobbin still remains in the device (or in the hook),
press
section to feed the bobbin to a position at which the bobbin
can be taken out.
Then, carry out the operation procedure (1) or (2).
Be sure to carry the bobbin to the bobbin setting sec-
tion with
the bobbin which is placed in the hook where nec-
essary. If you attempt to remove the bobbin directly
from the hook, the sewing machine may operate
while no bobbin is placed in the hook.
(In the case the previous sewing has been normally finished, and
one bobbin is placed in the hook and the other bobbin is placed in
the bobbin setting section.)
1)
Turn the power to the device.
A to display the sewing screen. Once the sewing
2)
Press
screen is displayed, sewing can be started.
In other words, the operation required in the aforementioned state
is only to turn ON the power to the device. Note that the number
of stitches is set at the value that is effective at the end of previous
sewing. So, sewing can be started continuously from the previous
sewing.
– 113 –
A to make the bobbin setting
A before removing
Advertisement
Table of Contents
