Table of Contents
Advertisement
C
③ Displaying the pattern position correction screen
D
After the needle entry point you want to use as the reference
position is reached, press automatic correction button
F
to display the pattern position correction screen.
For the pattern position correction, as many as two points
E
can be designated as the reference position according to the
intended use.
If you want to set two reference points, it is necessary to set
them so that each of the reference points has different coordi-
nates.
Items to be set are as described below.
C
Enable/disable of the correction value
D
Coordinates of the reference position
E
Correction amount for the reference-position coordinates
④ Setting coordinates of the reference position D
When teaching button
current needle entry point are set as coordinates of the refer-
ence position, and the position correction teaching screen is
displayed.
At this time, coordinates of the current needle entry point are
set as coordinates of the reference position.
G
⑤ Teaching correction amount E
H
Input a correction amount for the reference position.
When move button
travels from the reference-position coordinates, and the travel
amount is displayed as the correction amount.
⑥ Confirming the correction amount
When enter button
coordinates and the correction amount are confirmed, and the
screen returns to the pattern position correction screen.
– 64 –
Setting item for correcting the position
F is pressed, coordinates of the
G is pressed, the presser foot
H is pressed, the reference-position
B
Advertisement
Table of Contents
