Overview Of Licenses - Siemens SINAMICS S120 Function Manual

Basic information about the drive system
14.3 Licensing
Information on performance expansion
The "Performance" option (Article number: 6SL3074-0AA01-0AA0) is required as of the 4th
axis (for SERVO/VECTOR) or as of the 7th V/f axis for the CU320-2 is (see Availability of SW
functions (Page 905)). If the number of axes is exceeded, error F13000 is output and the LED
READY on the Control Unit flashes red at 2 Hz.
When using axis-granular options, such as the extended safety functions, a license is required
for each axis.
14.3.2

Overview of licenses

Overview of licenses
A license overview page is included in the commissioning tool.
①
②
③
④
⑤
⑥
⑦
⑧
Figure 14-4
The following actions are possible in the license overview:
● Obtain a status overview of the individual licenses of your drive system.
● Display license key and enter (see Chapter "Displaying/entering the License Key
(Page 784)").
778
Display regarding the current license status (e.g. underlicensed)
System response to the current license status (e.g. prevents the drive from being switched on
again.)
Displays the required number of licenses compared with the number of licenses included in the
license key. (Note: For operation, the number of available licenses ≥ the number of licenses
required.)
Displays the current status of the Trial License (e.g. Trial License Mode not active)
Button to display and copy the serial number of the memory card
Button for activating the Trial License Mode
Button for displaying and entering the License Key
List of all used functions that require a license
Displaying the license overview (example)
Function Manual, 06/2019, 6SL3097-5AB00-0BP2
Drive functions