Siemens SINAMICS S120 Function Manual page 757

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Communication settings

If you reset the converter to the factory settings, the IP address of the service interface, the

PROFINET IP address and the PROFINET device name are not cleared.

In order to reset the converter in the web server to factory settings, proceed as follows:

1. In the "Restore factory settings" adjustment area, click on the "Restore factory settings"

2. Acknowledge the confirmation prompt. The converter is reset, and then restarted.

If the LED on the converter lights up green, resetting is complete.

You have finished resetting the converter to factory settings. When the web server is called

again, the initial setup is started (see Chapter "Password forgotten (Page 758)").

Drive functions

Function Manual, 06/2019, 6SL3097-5AB00-0BP2

13.5 Backup and restore