Western Digital Ultrastar Serv60+8 User Manual page 374

User Guide
e. Link Status: The Link Status defaults to Disable. This configures the IPv6 network
f. IP Address: The IP Address is uneditable by default. Select the option Use the
g. Prefix Length: The IPv6 Prefix Length is uneditable by default. Select the option Use the
h. Gateway: The Gateway is uneditable by default. The Use the following IP address
i. Primary DNS Server: The Primary DNS Server is uneditable by default. The Use the
j. Secondary DNS Server: The Secondary DNS Server is uneditable by default. The Use
Step 3 : Save the new settings.
A message notifying that the parameters of the IPv6 Network Settings section have been
set will appear.
5.4.5.3 Configuring VLAN Settings
Note: The user is required to log in with a user that has Operator privileges or higher to
configure VLAN Settings. For more information on how to log into the BMC Web GUI, see:
Logging into the BMC Web GUI (page
Step 1 : From the Menu Bar, select Configuration > VLAN.
The VLAN Settings window will appear.
settings to disabled. Select another option to enable the link status. The user may
select the option to enable DHCP or to use a specific IP Address.
following IP address to enter a specific IP Address into the field next to IP address.
following IP address to enter a specific Prefix Length into the field.
Note: The Prefix Length is used to identify how many bits of a Gobal
Unicast IPv6 Address are available in the network.
option must be selected to input a specific gateway.
following IP address option must be selected to input the primary DNS server.
the following IP address option must be selected to input the secondary DNS server.
346).
5. System Management
5.4 BMC Web GUI
365