Western Digital Ultrastar Serv60+8 User Manual page 203

User Guide
4.11 Add-in Card Replacement
Note: The Add-in cars is not hot swappable. The enclosure must be powered-down,
disconnected from all cabling, and removed from the rack before replacing the Add-in card.
Table 46: Procedure Info
Required Tools
•
T7 Torx Screwdriver
Step 1 : Uncable the CMA(s).
a. Open all of the basket clips on the CMA(s).
b. Remove one cable at a time from the arm, making sure not to put too much strain on the
Step 2 : Remove the CMA(s).
a. Release all of the connectors that attach the CMA(s) to the enclosure and the rail.
•
Figure 223: Open Baskets
arm.
Required Parts
T7 Torx screws
4. Part Replacement
4.11 Add-in Card Replacement
# of People Required Time Required
3 1h 30m
194