Western Digital Ultrastar Serv60+8 User Manual page 243

User Guide
Table 48: Procedure Info
Required Tools
•
Long T15 Torx
Screwdriver
•
# 2 Philips Screwdriver
•
Long T10 Torx
Screwdriver
•
Cable Ties (for
configurations
with greater than
10 total cables)
•
Tape Measure
•
Step 1 : Place the CMA into service position.
a. Unlatch the CMA at the elbow connector by pressing the blue release button to unlatch
the connector from the rail.
b. Swing the CMA away from the enclosure.
c. The arm should be extended away from the enclosure as shown in the following example.
•
Reuse: M5 x 12mm T15
Flat Head Torx screws
•
Reuse:Included Washers
•
Low-Profile M4 x 3.2mm
Philips screws (included
•
Level
Figure 281: Unlatching a CMA Connector
Required Parts
with rail assembly)
Optional (if
using CMA Tray):
4. Part Replacement
4.13 Rails Replacement
# of People Required Time Required
3 Total (2 for Team
Lifting Purposes and
1 to Guide and Spot)
~1h
234