Western Digital Ultrastar Serv60+8 User Manual page 269

User Guide
4.14 Chassis Replacement
Table 49: Procedure Info
Required Tools
• Long T15 Torx
Screwdriver
•
# 2 Philips Screwdriver
•
T30 Torx Screwdriver
•
Tape Measure
•
Step 1 : Place the CMA into service position.
a. Unlatch the CMA at the elbow connector by pressing the blue release button to unlatch
b. Swing the CMA away from the enclosure.
c. The arm should be extended away from the enclosure as shown in the following example.
•
•
•
Low-Profile M4 x 3.2mm
Philips screws (included
Level
the connector from the rail.
Figure 318: Unlatching a CMA Connector
Required Parts
M5 x 12mm T15 Flat
Head Torx screws
Included Washers
with rail assembly)
4. Part Replacement
4.14 Chassis Replacement
# of People Required Time Required
3 ~2h
260