Western Digital Ultrastar Serv60+8 User Manual page 371

User Guide
Figure 469: IPv4 Network Settings — Enabled
a. Hostname: The hostname is autogenerated by default. To change the defaulted
hostname, type a new hostname into the field.
b. Enable LAN Failover: The Enable LAN Failover is defaulted to disbaled. Select the
checkbox to enable this feature.
c. LAN Channel: The LAN Channel option defaults to Channel-3. Choose another option
from the drop-down list to change the value.
d. MAC Address: The MAC Address is autogenerated.
e. NIC Description: Defaulted to Dedicated to BMC Web GUI with no option to change
the value.
f. Link Status: The Link Status defaults to Obtain an IP address automatically (use
DHCP). This configures the IPv4 network settings to use DHCP for the IP Address,
Subnet Mask, Gateway, Primary DNS Sever, and Secondary DNS Server. The other
options allow for the user to choose a specific IP Address or to disable the IPv4
Network altogether.
g. IP Address: The IP Address is obtained by DHCP by default. Select the option Use the
following IP address to enter a specific IP Address into the field next to IP address.
h. Subnet Mask: The Subnet Mask is obtained by DHCP by default. The Use the following
IP address option must be selected to input a specific subnet mask.
i. Gateway: The Gateway is obtained by DHCP by default. The Use the following IP
address option must be selected to input a specific gateway.
j. Primary DNS Server: The Primary DNS Server is obtained by DHCP by default. The Use
the following IP address option must be selected to input the primary DNS server.
Note: No changes are needed to this section if DHCP is the preferred method.
The BMC Web GUI is set to DHCP by default.
5. System Management
5.4 BMC Web GUI
362