Western Digital Ultrastar Serv60+8 User Manual page 318

User Guide
Step 64 : Install the second PSU.
Step 65 : Install the crossbar onto the CMA mounting bracket.
a. Align the crossbar with the mounting peg facing down and pointing toward the CMA
mounting bracket.
b. Insert the peg on the underside of the crossbar into the slot on the CMA mounting
bracket.
c. Swing the crossbar so that the thumbscrew lines up with the mounting hole on the
opposite side of the enclosure.
d. Press the crossbar against the CMA mounting bracket and secure the crossbar in place by
pressing and turning the thumbscrew clockwise until snug.
a. Check that the crossbar is fully secured to the CMA mounting bracket by pulling on the
bar to ensure it does not move.
Step 66 : Cable the CMA(s).
CMA Standard:
a. Unlatch the elbow side of the arm(s) by pressing the blue button labeled "push," and then
swing the arm(s) open.
b. Open all of the baskets.
Figure 401: Cinching Cable Retention Clip
4. Part Replacement
4.14 Chassis Replacement
309