Western Digital Ultrastar Serv60+8 User Manual page 244

Hide thumbs Also See for Ultrastar Serv60+8:

Table of Contents

Step 2 : Disconnect the Enclosure from power.

a. Locate the redundant PSUs at the rear of the enclosure.

b. Detach the cable retention clip from both power cords.

c. Power down the enclosure by disconnecting both power cables, one from each PSU.

Step 3 : Uncable the CMA(s).

Figure 282: CMAs in service position (Cables not shown)

Figure 283: Cable Retention Mechanism

4. Part Replacement

4.13 Rails Replacement