Western Digital Ultrastar Serv60+8 User Manual page 216

User Guide
e. As the chassis is slid into the rack, position one installer at the rear of the rack to ensure
that the pegs on the sides of the cover will slide correctly into the rear cover alignment
brackets on both sides of the rack. If the chassis does not install smoothly or snags, check
that the rear cover alignment brackets are not interfering with the chassis sidewalls, and
try again.
Step 18 : Now that the chassis is installed, test the installation by sliding the enclosure in and out of the
rack a minimum of three times. If the enclosure binds, catches, or displays any incorrect motion
or behavior repeat the installation.
Step 19 : Install the CMA(s).
a. Orient the CMA so that the elbow is on the left hand side.
b. Attach all three of the connectors to the brackets on the rails. There should be one at the
elbow side and two at the other end.
Figure 245: Safety Latch Release
Note: Adjustments of the vertical rack rails may be required to fix any issues that
may occur.
Note: CMA has one arm, to be installed at the lower position. This arm should
have the elbow on the left side.
4. Part Replacement
4.11 Add-in Card Replacement
207