Abnormal Noise During Printing - Xerox Phaser 6500 Service Manual

Abnormal Noise During Printing

Phaser 6500/WorkCentre 6505 Service Manual
Troubleshooting Procedure Table
Step Actions and Questions
1 Test the Fan (page 4-32): Service Mode >
Engine Diag > Motor Test > Fan.
Is the noise coming from the Fan?
Initial Actions
• Check for obstructions or debris in the media path.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Separator Roller, PL2.1.5
Feed Roller Assembly, PL3.2.4
Registration Roller, PL3.2.9
Metal Registration Roller, PL3.2.10
Imaging Unit, PL4.1.21
Fuser, PL6.1.1
Transfer Belt, PL6.1.7
Sub Drive Assembly, PL7.1.1
Main Drive Assembly, PL7.1.2
Fan, PL8.1.1
Duplex Unit, PL11.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 Is the noise present when paper is fed
from the Tray?
2 Check the paper condition.
Is the paper dry and approved?
3 Is the noise present when paper is fed
from the Tray?
4 Check the Separator Holder.
1. Remove the Tray.
2. Rotate the Separator Roller with
your finger.
Does the roller rotate smoothly?
Xerox Internal Use Only
General Troubleshooting
Yes
Replace the
Fan.
(page 8-119)
Wiring and Plug/Jack Map References
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Go to step 5.
No
Replace the
LVPS.
(page 8-124)
No
Go to step 6.
Replace the
paper, then
go to step 3.
Complete
Replace the
Separator
Holder
(page 8-6).
4-75