Iot Tray1 Misfeed Jam - Xerox Phaser 6500 Service Manual

IOT Tray1 Misfeed JAM

Phaser 6500/WorkCentre 6505 Service Manual
Applicable Error Code
• 071-100
Troubleshooting Reference Table
Applicable Parts
Cassette Assy 250 (PL2.1.1)
■
Separator Holder Assy (PL2.1.5)
■
Drive Clutch and Regi Bearing Kit
■
(PL3.1.97)
Feed Solenoid Kit (PL3.1.99)
■
Left Side Harness Assy (PL3.1.18)
■
Feed Roller Assy (PL3.2.4)
■
Registration Input Actuator
■
(PL3.2.11)
Registration Sensor (Sensor Photo)
■
(PL3.2.13)
Main Drive Assy (PL7.1.2)
■
Feed Drive Assembly (PL7.1.4)
■
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Troubleshooting Procedure
Step Actions and Questions
1 Check the paper condition.
Is the paper in Tray 1 wrinkled or
damaged?
2 Does the error still occur when
printing?
3 Reload Tray 1 with new paper.
Does the error still occur when
printing?
4 Open and close the Front Cover,
making sure to latch correctly.
Does the error still occur when
printing?
5 Perform the procedure "Main Drive
Assembly" on page 4-29.
Does the Main Motor (Main Drive
Assy) operate properly?
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 3 - SFP IP Board, LVPS, and Drive"
■
on page 10-8
"Map 4 - SFP MCU Board" on
■
page 10-9
"SFP Media Feed" on page 10-27
■
"SFP Main Drive" on page 10-28
■
"Map 8 - MFP LVPS, IP Board, and
■
Drive" on page 10-17
"Map 9 - MFP MCU Board and HVPS"
■
on page 10-18
"MFP Media Feed" on page 10-40
■
"MFP Main Drive" on page 10-41
■
Yes
Replace with
new dry paper,
then go to step
2.
Go to step 3.
Go to step 4.
Go to step 5.
Go to step 6.
No
Go to step 3.
Complete.
Complete.
Complete.
Go to step 19.
3-95