Skew - Xerox Phaser 6500 Service Manual

Print-Quality Troubleshooting

Skew

Initial Actions
5-32
The printed image is not parallel with both sides of the paper.
• Check the media path.
• Ensure there are no debris on the transfer path.
• If feeding through the Manual Feed slot, try feeding from Tray 1.
Troubleshooting Reference Table
Applicable Notes
Separator Roller, PL2.1.5
Feed Roller Assembly, PL3.2.4
Registration Roller, PL3.2.9
Metal Registration Roller, PL3.2.10
The Tray is recommended for paper feeding because paper fed via the Manual
Feed slot is prone to skew depending on how the sheet is fed.
Troubleshooting Procedure
Step Actions and Questions
1 Inspect the media being used.
Is it approved paper?
2 Is the image printed correctly?
3 Check media condition.
Is the media dry and
recommended?
4 Is the image printed correctly?
5 Open and close the Front Cover.
Does the Front Cover latch close
properly?
6 Is the image printed correctly?
Xerox Internal Use Only
http://www.manuals4you.com
Example Print
Yes
Go to step 3.
Complete
Go to step 5.
Complete
Complete
Complete
Phaser 6500/WorkCentre 6505 Service Manual
Skew 2
No
Load approved
media, then go
to step 2.
Go to step 3.
Replace the
media, then go
to step 4.
Go to step 5.
Replace the
defective parts,
then go to step
6.
Go to step 7.