IOT Fuser Near Life
Phaser 6500/WorkCentre 6505 Service Manual
Applicable Error Code
•
010-421
Troubleshooting Reference Table
Applicable Parts
Fuser Assy (PL6.1.1)
■
MCU Board (SFP PL8.2.13;
■
MFP PL8.3.6)
Warning
To avoid possible burns, allow the Fuser Assy to cool before beginning the
procedure.
Troubleshooting Procedure
Step Actions and Questions
1
Is the Fuser Assy installed correctly?
2
Does the error still occur when the
power is turned Off and On?
3
Replace the Fuser Assy. (page 8-10)
Does the error still occur when the
power is turned Off and On?
NOTE After replacing the Fuser, be
sure to reset the Fuser counter.
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 1 - SFP Print Engine" on
■
page 10-6
"Map 4 - SFP MCU Board" on
■
page 10-9
"Map 6 - MFP Print Engine" on
■
page 10-15
"Map 9 - MFP MCU Board and HVPS"
■
on page 10-18
Yes
Go to step 3.
Go to step 3.
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
No
Reseat the
Fuser Assy,
then go step 2.
Complete.
Complete.
3-43