First Print Output Time - Xerox Phaser 6500 Service Manual

Color laser printer/multi-function printer

Hide thumbs Also See for Phaser 6500:

Table of Contents

General Information

First Print Output Time

Control Panel

NOTE When the printer receives a print or Fax job or the Wake Up/Power Saver

button is pressed, the printer exits the Power Saver mode and enters the

First Print Output Time (FPOT) is defined as a time from when the engine receives

a Start signal in Ready state, until a single page is delivered to the output tray.

The following conditions are applied:

The Controller does not keep the print engine waiting

The printer is at Ready mode

Paper is A size Short Edge Feed (SEF)

Process control time is not included

a. Maximum FPOT time is 18 seconds for mono or color. If the preceding job was all mono, and

the first page in the next job is mono, FPOT is 12 seconds. If the last job had any single color

page, and the first page in the next job is color, FPOT is 13 seconds. If the printer has to switch

modes, FPOT is 18 seconds.

Xerox Internal Use Only

http://www.manuals4you.com

The system is at Pause.

The system is Off.

The Scanner and ADF are off.

The system is Off.

LCD: Off, LCD Backlight: Off

LED: Wake Up LED is On.

13.0 sec. or less

12.0 sec. or less

Phaser 6500/WorkCentre 6505 Service Manual

Workcentre 6505