Iot Feeder 2 Jam - Xerox Phaser 6500 Service Manual

IOT Feeder 2 JAM

Phaser 6500/WorkCentre 6505 Service Manual
Applicable Error Code
• 072-101
Troubleshooting Reference Table
Applicable Parts
Cassette Assy 250 (PL2.1.1)
■
Separator Holder Assy (PL2.1.5)
■
Left Side Harness Assy (PL3.1.18)
■
Drive Clutch and Regi Bearing Kit
■
(PL3.1.97)
Feeder Assy (PL3.1.98)
■
Feed Solenoid Kit (PL3.1.99)
■
Feed Roller Assy (PL3.2.4)
■
Registration Input Actuator
■
(PL3.2.11)
Registration Sensor (Sensor Photo)
■
(PL3.2.13)
Main Drive Assy (PL7.1.2)
■
Feed Drive Assembly (PL7.1.4)
■
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Troubleshooting Procedure
Step Actions and Questions
1 Check the paper condition.
Is the paper in Tray 1 or Tray 2
wrinkled or damaged?
2 Does the error still occur when
printing?
3 Load new paper in Tray 1 or Tray 2.
Does the error still occur when
printing?
4 Check the Front Cover for latching.
Open and close the Front Cover, and
then latch correctly.
Does the error still occur when
printing?
5 Perform the procedure "Main Drive
Assembly" on page 4-29.
Does the Main Motor (Main Drive
Assy) operate properly?
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 4 - SFP MCU Board" on
■
page 10-9
"Map 9 - MFP MCU Board and HVPS"
■
on page 10-18
"Map 5 - SFP Optional Feeder" on
■
page 10-10
"Map 10 - MFP Optional Feeder" on
■
page 10-19
"SFP Option Feeder" on page 10-35
■
"MFP Option Feeder" on page 10-50
■
Yes
Replace with
new, dry paper,
then go to step
2.
Go to step 3.
Go to step 4.
Go to step 5.
Go to step 6.
No
Go to step 3.
Complete.
Complete.
Complete.
Go to step 19.
3-105