Removing And Installing 3.5" Drives From/In Tray - Siemens SIMATIC IPC1047 Operating Instructions Manual

Expanding and assigning parameters to the device
6.2 Drives
6.2.3.3

Removing and installing 3.5" drives from/in tray

Requirement
● The tray has been removed, see section "Removing and installing a tray from/in the drive
cage (Page 65)".
● 1 drive
● 1 soft mounting base
Procedure
Removal
1. Place the tray on the mounting base so that it rests as shown.
2. Pull the two guides of the tray outwardly until the marked nipples release the drive.
3. Only touch the sides of the drive.
4. Remove the drive by lifting it upwards, and place it carefully on the mounting base next to
the tray.
Installation
Proceed in reverse order.
66
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047