Siemens SIMATIC IPC1047 Operating Instructions Manual page 75

Procedure
1. Screw the fixing pins onto the riser
2. Connect the riser card to the moth-
3. Release the lock
4. In the case of a longer PCI expan-
5. Press the outside of the guide rail
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
The PCI expansion card shown in the
following serves as an example only.
card.
Place the fixing pins onto the inside
of the enclosure and screw them in
place from the outside.
erboard at the marked position.
⑤
(see step 5)
and remove the slot bracket cover.
Place the expansion card onto the
marked slot of the riser card.
Slide the expansion card into the slot
in the arrow direction as far as it will
go without tilting the card.
Note the following:
• The guide rail runs through the
③
eye on the left.
• On the outside, the guide rail
bracket runs into the locking
⑤
mechanism .
sion card, place a card retainer onto
the enclosure from the inside and
screw it in place from the outside.
bracket against the locking element
and screw it in place, as shown.
Expanding and assigning parameters to the device
6.3 Expansion cards
75