Changing A Backplane For Removable Tray - Siemens SIMATIC IPC1047 Operating Instructions Manual

6. Insert the backplane
back.
Check the following:
– The backplane lies flat at the back in the drive cage.
– All centering openings
– The backplane is clipped in behind the latches
– All backplanes lie exactly underneath each other, vertically aligned, when viewed from
7. Reinstall the required blanking plates or removable trays.
8. Insert the cover
9. At the backplane, connect the data cables with the corresponding interfaces on the
motherboard or the hardware RAID controller.
10.Connect the power supply.
11.Close the device.
6.2.2.4

Changing a backplane for removable tray

The backplane is installed from inside at the back end of the drive cage type A and is
equipped with interfaces for data cable to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
④
into the drive bay from the front and snap it into place at the
⑤
⑦
above .
②
into the front of the device.
Expanding and assigning parameters to the device
of the backplane lie in the centering pins.
⑥
.
6.2 Drives
61