Removing And Installing Hard Disk Drives (Back) - Siemens SIMATIC PC RI25/45 Technical Description

System Unit
1.3.7

Removing and Installing Hard Disk Drives (Back)

Procedure Proceed as follows to replace or install hard drives:
Figure 1-10 Removing and installing hard disk drives
1-12
You can install up to two additional hard disk drives in the support located
at the back of your PC.
The support is mounted with three screws (see Figure 1-10). Two of them are
directly accessible at the back of the system unit. The third screw can only
be reached inside the unit from the top. The hard disk drives must be fixed
with screws at the upper and lower end of the support.
Then connect the installed hard disk drives, CPU board and power supply
by plugging in the corresponding connecting cables.
Mounting screws
SIMATIC PC RI25/45, Technical Description
C79000-G7076-C808-01