Bios Description; Ipmi Setup - Siemens SIMATIC IPC1047 Operating Instructions Manual

7.5

BIOS description

BIOS Setup program
The BIOS Setup program, or BIOS Setup for short, is located, together with the setup
parameters, in a FLASH block on the motherboard. You change the setup parameters of the
device in the BIOS Setup. Examples: System time, hard disks or boot order.
Press <Del> during booting to open the BIOS Setup.
Changing the device configuration
Your device configuration is preset for operating with the included software. You should only
change the default setup parameters if you have made technical changes to your device, or
if a fault occurs when the device is switched on.
Note
Documentation
You can find the BIOS description from the manufacturer at
Supermicro (https://www.supermicro.com/products/motherboard/xeon/c600/x10dri.cfm)
7.6

IPMI Setup

The IPMI Setup is documented in detail by the manufacturer:
IPMI (https://www.supermicro.com/solutions/IPMI.cfm).
The procedure is briefly outlined below.
Procedure
1. Set up the dynamic address assignment via DHCP
Alternatively, assign a fixed IP address, e.g. "192.168.10.253".
2. Establish a connection to IPMIView, see section "Monitoring functions (Page 51)".
3. Set up the remote control via iKVM, also with IPMIView.
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
Device maintenance and repair
7.5 BIOS description
99