Siemens SIMATIC IPC1047 Operating Instructions Manual page 79

Hide thumbs Also See for SIMATIC IPC1047:

Table of Contents

Installing the RAID adapter card

For installation, follow the description in section "Installing and removing expansion cards

(Page 73)".

Configuring the RAID adapter card

Note Management of the Hardware RAID system

When setting up the Hardware RAID system, set the write cache of the RAID controller as

follows (see the additional documentation of Adaptec):

• Write Caching - Enable with Backup Unit

• create RAID via: Build/Verify

After replacement of the RAID adapter card, configure it in the BIOS setup as follows:

Note

The key combination <CTRL+A> is only effective in "Legacy" mode. If the "Boot Type"

parameter is set to "UEFI Boot Type in the "Boot" menu in the BIOS setup, the RAID

hardware is configured by using the "Device Management" button in the BIOS selection menu.

1. Switch on the device.

2. During the boot phase, press the key combination <CTRL+A> when prompted to do so.

If the "Boot Type" parameter is set to "Dual Boot Type" in the "Boot" menu in the BIOS

setup and an EFI boot medium is available, you must press the <ENTER> key after

having pressed the <CTRL+A> within 1 second.

The system starts if you do not press the <ENTER> key in time.

3. Assign the parameters under "Controller Configuration" as follows:

SIMATIC IPC1047

Operating Instructions, 07/2019, A5E45118479-AB

Expanding and assigning parameters to the device

6.3 Expansion cards

Table of Contents