Installing A Second Com Interface (Optional) - Siemens SIMATIC IPC1047 Operating Instructions Manual

Expanding and assigning parameters to the device

6.4 Installing a second COM interface (optional)

Note
The settings shown correspond to the default setting in the delivery state of the device.
Difference in the parameters compared to the default setting of the Hardware RAID
adapter card after replacement:
• "Drives Write Cache = Disabled", which means the write cache of the hard disk is
• "Alarm Control = Disabled", which means the acoustic alarm in case of a fault is
6.4 Installing a second COM interface (optional)
Requirement
● The device is open; see section "Open the device. (Page 53)".
● Tx10 screwdriver
Procedure
1. Remove the screw on slot 1.
2. Remove the associated slot bracket, similar to the figure
3. Insert the slot bracket with the pin connector of the COM interface and screw it in place.
4. Insert the plug connector onto the marked location on the motherboard.
No other steps are needed for installing the COM interface.
80
switched off.
switched off
②
.
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047