Removing And Installing Internal Hdd/Ssd - Siemens SIMATIC IPC RW-543A Operating Instructions Manual

Expanding and assigning parameters to the device
6.4 Drives (HDD/SSD)
Procedure
1. Remove the drive module (Page 56).
2. Secure the hard disk in the corresponding slot.
Note
• If you want to install a 2.5" hard disk drive or 3.5" hard disk drive, you need to install a
• Recommend installing the hard disk in the middle slot of the drive module.
3. Install the driver cage again.
4. Connect the power and data cables to the drive.
5. Install the drive bay according to the reverse steps of removing the drive bay.
6.4.4

Removing and installing internal HDD/SSD

Requirement
• The device is fully disconnected from the line voltage, see "Switching off the device
(Page 44)".
• The device is open, see important information in "Open the device (Page 49)".
• The drive bay is taken out of the chassis.
58
corresponding converter in addition.
Operating Instructions, 03/2023, A5E52332059-AA
SIMATIC IPC RW-543A