Installing A Backplane For Removable Tray - Siemens SIMATIC IPC1047 Operating Instructions Manual

3. Push the 5.25" adapter for the removable racks from the front into the drive cage.
4. Attach the data cables to the desired connectors on the motherboard or the hardware
RAID controller and to the adapter module.
5. Connect the power supply.
6. Close the device.
6.2.2.3

Installing a backplane for removable tray

The backplane is installed from inside at the back end of the drive cage type A and is
equipped with interfaces for data cable to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
Requirement
● An original spare part, that is a backplane approved for this device, see notes in section
"Accessories and spare parts (Page 20)".
● The device is fully disconnected from the line voltage, see section "Switching off the
device (Page 39)".
● The device is open; see section "Open the device. (Page 53)".
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
Expanding and assigning parameters to the device
6.2 Drives
59