Siemens SIMATIC IPC1047 Operating Instructions Manual page 112

Standards and approvals
Software license agreements
If the device is supplied with pre-installed software, you must observe the corresponding
license agreements.
The following approvals are available for the device:
● Underwriters Laboratories (UL) according to Standard UL 61010-2-201 Second Edition,
File E85972
● Canadian National Standard CAN/CSA-C22.2 No. 61010-2-201 Second Edition
USA
Federal Commu-
nications Commis-
sion
Radio Frequency
Interference
Statement
Shielded Cables
Modifications
Conditions of
Operations
Responsible party for Supplier's Declaration of Conformity
Siemens Industry, Inc.
Digital Industries - Factory Automation
5300 Triangle Parkway, Suite 100
Norcross, GA 30092
USA
mail to: amps.automation@siemens.com
CANADA
Canadian Notice
Avis Canadien
WEEE Directive
The device is low-emission, recyclable and meets the requirements of the WEEE Directive
2012/19/EU on the disposal of waste electrical and electronic equipment. Siemens AG is
registered with Stiftung EAR, WEEE-Reg. No. DE 23691322.
112
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equip-
ment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accord-
ance with the instruction manual, may cause harmful interference to radio com-
munications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the inter-
ference at his own expense.
Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
Changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
(mailto:
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du
Canada.
amps.automation@siemens.com)
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047