Installing And Connecting The Device; Preparing For Installation; Checking The Delivery Package; Identification Data Of The Device - Siemens SIMATIC IPC1047 Operating Instructions Manual

Installing and connecting the device

3.1

Preparing for installation

3.1.1

Checking the delivery package

Electric shock and fire hazard due to damaged device
Damaged devices due to improper storage or transport may lead to personal injury and/or
damage to equipment.
Please make sure to observe the information in section "General safety instructions
(Page 21)".
Procedure
1. Check the packaging and package contents for visible transport damage.
If any transport damage is present at the time of delivery, lodge a complaint at the
shipping company in charge. Have the shipper confirm the transport damage
immediately.
2. Unpack the device at its installation location.
3. Keep the original packaging in case you have to transport the unit again.
4. Check the contents of the packaging and any accessories you may have ordered for
completeness and damage.
Please inform the delivery service immediately if the package contents are incomplete or
damaged or do not correspond with your order.
5. Please keep the documentation in a safe place. It is required for initial commissioning and
is part of the device.
6. Make a note of the identification data of the device (Page 29).
3.1.2

Identification data of the device

The device can be clearly identified with the help of this identification data in case of repairs
or theft.
Make note of identification data
Enter the following data in the table below:
Serial number
Order no.
Microsoft Windows Product Key
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
WARNING
SVP...
6BK...
3
29