Installing A 5.25" Adapter Module For Removable Trays - Siemens SIMATIC IPC1047 Operating Instructions Manual
Hide thumbs
Also See for SIMATIC IPC1047:
- Operating instructions manual (136 pages) ,
- Quick install manual (2 pages)
Table of Contents
Advertisement
Expanding and assigning parameters to the device
6.2 Drives
6.2.2.2
Installing a 5.25" adapter module for removable trays
Requirement
● The device is equipped with the drive cage type A.
● There is no drive or any other component in the mounting location for 5.25" components.
● An original spare part, that is a 5.25" adapter module approved for this device, see notes
in section "Accessories and spare parts (Page 20)".
● The device is fully disconnected from the line voltage, see section "Switching off the
device (Page 39)".
● The device is open; see section "Open the device. (Page 53)".
Procedure
1. Unlock the drive mounting bar together with the blanking plate by pressing laterally
against the surfaces
direction of the arrow.
2. Remove the blanking plate.
58
①
and push the drive mounting bar forward from the device in the
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047
Advertisement
Table of Contents
