Installing The Software; Back-Up Authorization Or License Key - Siemens SIMATIC IPC1047 Operating Instructions Manual

Processor type and clock frequency
When a processor is replaced, perform a BIOS update. The microcode matching the
processor is loaded in the process.
Note
Damage to the processor due to high clock frequency
If the installed processor is operated with a higher clock frequency than permitted, it can be
destroyed or cause loss of data.
Operate the processor only at a clock frequency that is equal to or less than the permitted
clock frequency.
7.4

Installing the software

This section contains information on installing and restoring the operating system.
Depending on the configuration, the device has no operating system or one of the following
operating systems:
● Windows 10, pre-installed
● Windows Server 2016, only license and drivers, not pre-installed
You can find additional information on the pre-installed operating system on the Internet
under:
● Windows 10 on the supplied USB stick
(https://support.industry.siemens.com/cs/ww/en/view/109749498)
7.4.1

Back-up authorization or license key

Procedure
● Check whether you can back-up your authorization or license key from the drive and
perform this procedure if possible.
● If backup is not possible, please contact Customer Support. There you can obtain
information necessary for corresponding software authorization.
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
NOTICE
Risk of data loss
If "Restore system partition only" is set all data on drive C: (system partition) will be
deleted. All data, user settings and all authorizations or license keys on drive C: are lost!
All data on drive C: will be completely deleted, reformatted and overwritten with the
original factory software.
If "Restore entire drive" is set ALL data, user settings, authorizations or license keys will
be lost on the entire drive.
Device maintenance and repair
7.4 Installing the software
91