Siemens SIMATIC IPC1047 Operating Instructions Manual page 68

Expanding and assigning parameters to the device
6.2 Drives
Installation
1. Place the drive next to the tray as shown. Make sure that the threads and holes are even.
2. Touching only the sides of the drive, move it left into the tray while keeping it even.
3. Fix the drive and tray in position at the center and carefully turn both over: the drive
(rating plate) faces downward, see figure above.
Ensure that each hole of the tray is positioned exactly over the threads of the drive.
4. Screw on the drive from behind. Do not tighten the screws too much. Do not exceed the
maximum tightening torque of 0.7 Nm.
Installation in vertical format
68
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047