Mounting The Device - Siemens SIMATIC IPC1047 Operating Instructions Manual

Installing and connecting the device

3.2 Mounting the device

3.2.2 Mounting the device
Mounting types
You can mount the device as follows:
● Mounting with cabinet brackets
The device can be installed horizontally in control cabinets and 19" rack systems.
This mounting type meets the requirements in accordance with IEC60297-3-100.
● Mounting on a device base
This mounting type meets the requirements in accordance with IEC60297-3-100.
● Mounting on telescopic rails
The device can be installed horizontally in control cabinets and 19" rack systems.
When telescopic rails are used for mounting, the device can be withdrawn fully from the
cabinet or rack.
Position of the fastening hole holes for telescopic rails
The fastening holes for the telescopic rails of the various manufacturers are labeled in the
following figure:
①
②
③
The telescopic rails are secured with M4 screws. The dimensions for the associated
mounting holes are listed in the section "Dimension drawing for telescope rails (Page 110)".
32
Manufacturer Cooolcase, article number 3001758
Manufacturer Rittal, article number TS 3659.190 for 800 mm cabinets
Manufacturer Schroff, article number type 20110-072
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047