Siemens SIMATIC IPC1047 Operating Instructions Manual page 97

Refresh
Load Driver
Delete
Extend
Format
New
Note
If you want to install the operating system on a data medium connected to a storage
controller unknown to the operating system, you have to integrate the driver of the storage
controller. Integrate this driver before you partition the data medium and before you install
the operating system. You will find more information on integrating the storage controller
under "Information for systems with RAID or AHCI controller" at the end of this section.
1. Make sure that the partition on which you want to install the operating system is large
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies, depending on the operating
system, how much RAM you have available and how much additional software you want
to use. Information on how the data medium is partitioned in its factory state is available
in the tables below.
2. Select the partition on which you want to install the operating system.
3. Click "Next".
Installation is started. The Windows operating system is installed on the data medium.
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
Updating
Integration of controller drivers unknown to the operating system and required for
installation. Please read the information under "Information for systems with
RAID or AHCI controller" at the end of this section.
Deleting a partition
Changing the partition size
Formatting a partition
Creating new partitions
Identification for error messages, for example, if the data medium was not for-
matted in the required "NTFS" format.
Device maintenance and repair
7.4 Installing the software
97