Chapter 4 Panel Display and
This chapter details the panel status and operation of ADSA-M series servo drive.
4.1 Panel Description
Name
Display
SEL Key
MODE Key
SHIFT Key
UP Key
DOWN Key
SET Key
Revision December, 2014
The single-group of seven-segment display is for displaying the
selected axis.
The five-group of seven-segment display is for displaying the
monitoring values, parameter values and setting values.
Axis selection
Switch to Monitor Mode / Parameter Mode / Alarm Display.
When in Editing Mode, press the MODE Key can switch to the
Parameter Mode.
The group code can be changed in Parameter Mode. When in
Editing Mode, moving the blinking bit to the left can adjust the higher
setting bit. The display of high/low digit can be switched in Monitor
Mode.
Change monitoring codes, parameter codes or setting values
Change monitoring codes, parameter codes or setting values
Display and save the setting value. It can switch the decimal or
hexadecimal format display in Monitor Mode.
In Parameter Mode, press the SET Key can enter Editing Mode.
Operation
Function
4-1