Function Description Of Capture (Data Capture) - Delta ASDA-M Series User Manual

ASDA-M

7.10.1 Function Description of CAPTURE (Data Capture)

The concept of CAPTURE is to capture the position of motion axis instantaneously by
using the external trigger signal DI5. Then save it in data array so as to be used for
motion control afterwards. Since CAPTURE is finished by hardware, there is no
problem of software delay. It also can accurately capture the high-speed motion axis.
The CAPTURE features provided by this servo drive is as follows.
Pulse Source
Trigger signal
Trigger method
Data storage
position
Capture number
Capture format
Auxiliary selection
DO.CAP_OK
Revision December, 2014
CAPTURE Features

Main encoder of the motor

Auxiliary encoder (linear scale)

Pulse command
The selected axis will be displayed in P5-37, the default value can
be written in before capture.
Note: When the source of COMPARE is CAP axis, the CAP
source cannot be changed.

Triggered byDI5, the response time is 5 usec.
Note: DI5 directly connects to CAPTURE hardware. Thus,
regardless the setting value of P2-14 (DI Code), CAPTURE
can work. When using CAPTURE, in order to avoid DI error,
system will force to disable DI function, which means the
setting will be P2-14=0x0100 automatically. Since the value
is not written into EEPROM, P2-14 will return to the default
value after re-power on.

Edge trigger can select contact A/B

It is capable to continuously capture more than one point.

It can set the trigger interval.
(The interval between this trigger and the next one.)

Data array. The start address is set by P5-36.

It is set via P5-38 and will not exceed the limit of data array.

32-bit (It has positive and negative.)

After capturing the first data, the CAP axis coordinate system
will be set to the value the same as P5-76.

After capturing the first data, the COMPARE function is
enabled automatically.

After capturing all points, PR procedure＃50 is triggered
automatically.

The default value is OFF.

After capturing the last point, this DO is ON.
Chapter 7 Motion Control
7-39