Table 11: Chassis Control Module Physical Dimensions; Table 12: Chassis Control Module Connectors; Table 13: Chassis Control Module Switches; Table 14: Chassis Control Module Leds - Juniper G10 CMTS Hardware Manual

Table 11: Chassis Control Module Physical Dimensions

Table 12: Chassis Control Module Connectors

Table 13: Chassis Control Module Switches

Table 14: Chassis Control Module LEDs

Specification Value
Height 233 mm (9.2 in.) module
262 mm (10.3 in., 6 U) front panel
Width 20 mm (0.8 in.)
(front panel width)
Depth 340 mm (13.4 in.)
(excluding front panel and cPCI connectors)
Connector Label Function
COM RS-232 DB-9 connector for serial interface.
Eth0 Fast Ethernet RJ-45 connector for CMTS management.
Switch Label Function
Cut-off Disables audible alarm signals. Causes ACO LED to illuminate.
Reset Depress for < 2 sec—Soft reset. Module is reinitialized.
Depress for > 2 sec—Hard reset. All module components, except Host Controller, are reset.
LED Label Color
Minor Green
Major Amber
Crit Red
Run Green / Red
ACO Green
∆1 ∆2
Green
IDE Green
Power Green / Red
USR1 Bi-color
USR2 Bi-color
Hot Swap Blue
Function
On—Event of priority Warning, Notice, Information, or Critical has occurred.
On—Event of priority Error has occurred.
On—Event of priority Emergency, Alert, or Critical has occurred.
Green—Module is active.
Red—Module has been deactivated.
On—Alarm Cutoff is activated.
On—Active module.
Off—Stand-by module (not used).
Not used.
Green—Power on.
Red—Fault present.
Not used.
Not used.
ON—Module is ready to be removed. Illuminates after the ejector release is
pressed. During hot insertion, LED is ON until ejectors are locked.
OFF during power up.
Chassis Control Module
Hardware Component Overview
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
41