Installing the server and connecting the peripheral devices
To install the server
Place the 1002rp server in its chosen location. If you are installing the server in a rack cabinet,
follow the instructions that are provided with the slide rails.
Connect peripheral devices as described in the remainder of this chapter.
Warning:
Do not connect the server to the power yet.
Preparing the modem
Introduction
You require a modem to support remote dial-up access to the Avaya CallPilot
modem also enables Avaya technical support to connect to your Avaya CallPilot server for
troubleshooting purposes. Avaya connects to your server only when you request technical
assistance.
Required equipment
To install the modem, you need the following equipment:
• an RJ-11 analog phone cord
• a power adapter cord
• an analog line jack
• tweezers, or a screwdriver small enough to use to adjust DIP switches
The following modem is provided with your server:
an analog external U.S. Robotics 56-Kbit/s modem (NTRH9078) that includes a 25-pin male
to 9-pin female shielded serial cable for your modem
®
44
Avaya CallPilot
1002rp Server Hardware Installation
®
server. The
December 2010