What's New In Version - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

What's New in Version 5.00

New features in version 5.00 of the InfiniiVision 5000 Series oscilloscope
software are:
• Serial triggering and decode options are now available.
• The :SAVE and :RECall command subsystems.
• Changes to the :HARDcopy sommand subsystem to make a clearer
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command
:HARDcopy:STARt (see
:HARDcopy:APRinter (see
:HARDcopy:AREA (see
:HARDcopy:INKSaver (see
:HARDcopy:PRinter:LIST (see
:RECall Commands (see
:SAVE Commands (see
:SBUS Commands (see
:TRIGger:CAN Commands (see
:TRIGger:IIC Commands (see
:TRIGger:LIN Commands (see
:TRIGger:SPI Commands (see
:TRIGger:UART Commands (see
:WAVeform:SOURce:SUBSource (see
page
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
distinction between printing and save/recall functionality.
page 240)
page
page 233)
page
page 297)
page 302)
page 316)
page
467)
Description
Starts a print job.
234) Sets the active printer.
Specifies the area of the display to print
(currently SCReen only).
237) Inverts screen colors to save ink when printing.
page 239) Returns a list of the available printers.
Commands for recalling previously saved
oscilloscope setups and traces.
Commands for saving oscilloscope setups and
traces, screen images, and data.
Commands for controlling oscilloscope
functions associated with the serial decode
bus.
page 365) Commands for triggering on Controller Area
Network (CAN) version 2.0A and 2.0B signals.
396) Commands for triggering on Inter-IC (IIC)
signals.
page 405) Commands for triggering on Local Interconnect
Network (LIN) signals.
page 413) Commands for triggering on Serial Peripheral
Interface (SPI) signals.
page 428) Commands for triggering on UART/RS-232
signals.
Selects subsource when :WAVeform:SOURce
is SBUS (serial decode).
1
What's New
23