Marker:y1Position - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:MARKer:Y1Position

Command Syntax
:MARKer:Y1Position <position> [suffix]
<position> ::= Y1 cursor position in NR3 format
<suffix> ::= {mV | V | dB}
The :MARKer:Y1Position command sets :MARKer:MODE to MANual, sets
the Y1 cursor position and moves the Y1 cursor to the specified value.
Query Syntax
:MARKer:Y1Position?
The :MARKer:Y1Position? query returns current Y1 cursor position. If the
front- panel cursors are off an error is returned. This is functionally
equivalent to the obsolete :MEASure:VSTArt command/query
Return Format
<position><NL>
<position> ::= Y1 cursor position in NR3 format
See Also
•
•
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 243
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MARKer:Y2Position"
":MEASure:VSTArt" on page 535
on page 242
on page 245
on page 247
on page 250
Commands by Subsystem
5
249