Recall:setup[:Start] - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:RECall:SETup[:STARt]

Command Syntax
:RECall:SETup[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:SETup[:STARt] command recalls an oscilloscope setup.
If a file extension is provided as part of a specified <file_name>, it must be ".scp".
N O T E
See Also •
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :RECall Commands"
":RECall:FILename" on page 298
":SAVE:SETup[:STARt]"
on page 297
on page 312
Commands by Subsystem
5
301