Trigger:uart:data - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:TRIGger:UART:DATA

Command Syntax
:TRIGger:UART:DATA <value>
<value> ::= 8-bit integer in decimal or <nondecimal> from 0-255
<nondecimal> ::= #Hnn where n ::= {0,..,9 | A,..,F} for hexadecimal
<nondecimal> ::= #Bnn...n where n ::= {0 | 1} for binary
The :TRIGger:UART:DATA command selects the data byte value (0x00 to
0xFF) for the trigger QUALifier when in UART mode. The data value is
used when one of the RD or TD trigger types is selected.
Query Syntax
:TRIGger:UART:DATA?
The :TRIGger:UART:DATA? query returns the current UART trigger data
value.
Return Format
<value><NL>
<value> ::= 8-bit integer in decimal from 0-255
See Also
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
(0x00-0xff)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 360
":TRIGger:UART:TYPE"
on page 354
on page 440
Commands by Subsystem
5
433