Function:source1 - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:FUNCtion:SOURce1

Command Syntax
:FUNCtion:SOURce1 <value>
<value> ::= {CHANnel<n> | GOFT}
<n> ::= {1 | 2 | 3 | 4} for 4ch models
<n> ::= {1 | 2} for 2ch models
The :FUNCtion:SOURce1 command is used for any :FUNCtion:OPERation
selection (including the ADD, SUBTract, or MULTiply channel math
operations and the FFT, INTegrate, DIFFerentiate, or SQRT transforms).
This command selects the first source for channel math operations or the
single source for the transforms.
The GOFT parameter is only available for the FFT, INTegrate,
DIFFerentiate, or SQRT functions. It lets you specify, as the function input
source, the addition, subtraction, or multiplication of two channels. When
GOFT is used, the g(t) source is specified by the
:FUNCtion:GOFT:OPERation, :FUNCtion:GOFT:SOURce1, and
:FUNCtion:GOFT:SOURce2 commands.
Another shorthand notation for SOURce1 in this command/query (besides SOUR1) is
N O T E
SOUR.
Query Syntax
:FUNCtion:SOURce1?
The :FUNCtion:SOURce1? query returns the current source1 for function
operations.
Return Format
<value><NL>
<value> ::= {CHAN<n> | GOFT}
<n> ::= {1 | 2 | 3 | 4} for 4ch models
<n> ::= {1 | 2} for 2ch models
See Also
•
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :FUNCtion Commands"
":FUNCtion:OPERation"
":FUNCtion:GOFT:OPERation"
":FUNCtion:GOFT:SOURce1"
":FUNCtion:GOFT:SOURce2"
on page 216
on page 223
on page 219
on page 220
on page 221
Commands by Subsystem
5
227