Measure:vtime - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:MEASure:VTIMe

Query Syntax
:MEASure:VTIMe? <vtime_argument>[,<source>]
<vtime_argument> ::= time from trigger in seconds
<source> ::= {CHANnel<n> | FUNCtion | MATH}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :MEASure:VTIMe? query returns the value at a specified time on the
source specified with :MEASure:SOURce. The specified time must be on
the screen and is referenced to the trigger event. If the optional source
parameter is specified, the current source is modified.
This query is not available if the source is FFT (Fast Fourier Transform).
N O T E
Return Format
<value><NL>
<value> ::= value at the specified time in NR3 format
See Also •
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :MEASure Commands"
":MEASure:SOURce"
":MEASure:TEDGe" on page 281
":MEASure:TVALue" on page 283
on page 257
on page 279
Commands by Subsystem
5
293