Save:image[:Start] - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:SAVE:IMAGe[:STARt]

Command Syntax
:SAVE:IMAGe[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :SAVE:IMAGe[:STARt] command saves an image.
If a file extension is provided as part of a specified <file_name>, it must match the
N O T E
extension expected by the format specified in :SAVE:IMAGe:FORMat.
The <internal_loc> option is only valid if :SAVE:IMAGe:FORMat is TIFF.
N O T E
See Also •
•
•
•
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :SAVE Commands"
":SAVE:IMAGe:AREA"
":SAVE:IMAGe:FACTors"
":SAVE:IMAGe:FORMat"
":SAVE:IMAGe:INKSaver"
":SAVE:IMAGe:PALette"
":SAVE:FILename" on page 304
":RECall:IMAGe[:STARt]"
on page 303
on page 306
on page 307
on page 308
on page 309
on page 310
on page 299
Commands by Subsystem
5
305