Trigger:iic:trigger[:Type] - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:TRIGger:IIC:TRIGger[:TYPE]

Command Syntax
:TRIGger:IIC:TRIGger[:TYPE] <value>
<value> ::= {STARt | STOP | READ7 | READEprom | WRITe7 | WRITe10
| NACKnowledge | ANACknowledge | R7Data2 | W7Data2 | RESTart}
The :TRIGger:IIC:TRIGger[:TYPE] command sets the IIC trigger type:
• STARt — Start condition.
• STOP — Stop condition.
• READ7 — 7- bit address frame containing
• R7Data2 — 7- bit address frame containing
• READEprom — EEPROM data read.
• WRITe7 — 7- bit address frame containing
• W7Data2 — 7- bit address frame containing
• WRITe10 — 10- bit address frame containing (Start:Address
• NACKnowledge — Missing acknowledge.
• ANACknowledge — Address with no acknowledge.
• RESTart — Another start condition occurs before a stop condition.
The short form of READ7 (READ7), READEprom (READE), WRITe7 (WRIT7), and WRITe10
N O T E
(WRIT10) do not follow the defined Long Form to Short Form Truncation Rules (see
page
Query Syntax
:TRIGger:IIC:TRIGger[:TYPE]?
The :TRIGger:IIC:TRIGger[:TYPE]? query returns the current IIC trigger
type value.
Return Format
<value><NL>
<value> ::= {STAR | STOP | READ7 | READE | WRIT7 | WRIT10 | NACK | ANAC
See Also
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
(Start:Address7:Read:Ack:Data). The value READ is also accepted for
READ7.
(Start:Address7:Read:Ack:Data:Ack:Data2).
(Start:Address7:Write:Ack:Data). The value WRITe is also accepted for
WRITe7.
(Start:Address7:Write:Ack:Data:Ack:Data2).
byte1:Write:Ack:Address byte 2:Data).
588).
| R7D2 | W7D2 | REST}
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 360
Commands by Subsystem
on page 354
5
403