Trigger:uart:width - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:TRIGger:UART:WIDTh

Command Syntax
:TRIGger:UART:WIDTh <width>
<width> ::= {5 | 6 | 7 | 8 | 9}
The :TRIGger:UART:WIDTh command determines the number of bits (5- 9)
for each message "byte" for the serial decoder and/or trigger when in
UART mode.
Query Syntax
:TRIGger:UART:WIDTh?
The :TRIGger:UART:WIDTh? query returns the current UART width setting.
Return Format
<width><NL>
<width> ::= {5 | 6 | 7 | 8 | 9}
See Also
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 360
":TRIGger:UART:TYPE"
on page 354
on page 440
Commands by Subsystem
5
441