Trigger[:Edge]:Slope - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:TRIGger[:EDGE]:SLOPe

Command Syntax
:TRIGger[:EDGE]:SLOPe <slope>
<slope> ::= {NEGative | POSitive | ALTernate}
The :TRIGger[:EDGE]:SLOPe command specifies the slope of the edge for
the trigger. The SLOPe command is not valid in TV trigger mode. Instead,
use :TRIGger:TV:POLarity to set the polarity in TV trigger mode.
Query Syntax
:TRIGger[:EDGE]:SLOPe?
The :TRIGger[:EDGE]:SLOPe? query returns the current trigger slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS | ALT}
See Also
•
•
•
Example Code
Example program from the start:
page 672
386
(see page 586)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 360
":TRIGger:TV:POLarity"
' TRIGGER_EDGE_SLOPE - Sets the slope of the edge for the trigger.
' Set the slope to positive.
myScope.WriteString ":TRIGGER:EDGE:SLOPE POSITIVE"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 354
on page 425
"VISA COM Example in Visual Basic" on