Channel<N>:Protection - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:CHANnel<n>:PROTection
Command Syntax
:CHANnel<n>:PROTection[:CLEar]
<n> ::= {1 | 2 | 3 | 4}
When the analog channel input impedance is set to 50
channels are protected against overvoltage. When an overvoltage condition
is sensed, the input impedance for the channel is automatically changed to
1 M
(reset) the overload protection. It allows the channel to be used again in
50
from the channel input. Reset the analog channel input impedance to 50
(see
protection.
Query Syntax
:CHANnel<n>:PROTection?
The :CHANnel<n>:PROTection query returns the state of the input
protection for CHANnel<n>. If a channel input has experienced an
overload, TRIP (tripped) will be returned; otherwise NORM (normal) is
returned.
Return Format
{NORM | TRIP}<NL>
See Also
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
Ω
. The :CHANnel<n>:PROTection[:CLEar] command is used to clear
Ω
mode after the signal that caused the overload has been removed
":CHANnel<n>:IMPedance"
"Introduction to :CHANnel<n> Commands"
":CHANnel<n>:COUPling"
":CHANnel<n>:IMPedance"
":CHANnel<n>:PROBe"
on page 181) after clearing the overvoltage
on page 179
on page 181
on page 185
Commands by Subsystem
Ω
, the input
on page 176
5
Ω
189