Furuno FMD-3200-BB Instruction Manual page 98

1. INITIAL SETTING AND ADJUSTMENT
[Change button]: Check the checkbox to show the [Change] button. Click the
[Change] button to show the [Vertical Graph (Middle)] hidden behind. Check the
checkbox of [Show] in [Change Button] to show the component hidden behind.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Secondary (Y2) Scale]: Check the check box to show the value input from the data
source of [Secondary].
[Mathematical Sign (Scale)]: Check the checkbox to show the minus sign (-) when
the value of the X-coordinate is minus.
[Mathematical Sign (Value)]: Check the checkbox to hide the minus sign (-) when
the value above graph is minus.
• Winch
[Title]: Enter the title of the component.
[Type]: Select [Main only] or [Port and Stbd]. For [Main only], the information of only
the main winch is shown. For [Port and Stbd], the information of each winch on both
the port and starboard is shown.
[Length]: Set the source and unit of length for rope.
[Power]: Set the source and unit for rope winding force.
[Speed]: Set the source and unit for rope winding speed.
[Start Value]: Set the minimum value of the bar.
[End Value]: Set the maximum value of the bar.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
• Winch Information
[Title]: Enter the title of the component.
[Length]: Set the source and unit of length for rope.
[Power]: Set the source and unit for rope winding force.
[Speed]: Set the source and unit for rope winding speed.
[Decimal Place]: Check the checkbox to show the value after decimal point.
1-92